PSC FALCON 315 Podręcznik Użytkownika Pobierz pdf (Strona 65)

Attaching a Bar Code Reader

User’s Guide

3. After a short timeout period, the laser switches to a full scanning

beam and reads the bar code.

• The default timeout period is one-half second.

Release Scan Mode

Release Scan mode provides greater control over the spotting beam:

1. Press and hold the laser trigger for the laser to emit a spotting beam.

• The spotting beam stays on for up to 5 seconds until the trigger is

released in Release Scan mode.

2. The laser switches to a full scanning beam and reads the bar code.

3. Turn off the full scanning beam by pressing and releasing the trigger.

To prevent accidental scanning, both modes require that the laser trigger is

held down to activate the spotting beam.

Attaching a Bar Code Reader

If a Falcon 31X or 32X does not have an integrated laser scanner, a bar code

reader can be attached to the connector at the top. The reader’s cable must

have a standard nine-pin squeeze connector at the end.

To attach a bar code reader:

• Match the orientation of the holes on the squeeze connector with

the pins on the Falcon’s connector.

• Push the squeeze connector onto the Falcon’s connector until it is

firmly in place. Refer to

Figure 22.

2314.book Page 55 Friday, July 12, 2002 1:42 PM

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 99 100

Brak uwag

PSC FALCON 315 Podręcznik Użytkownika Strona 65